Why is My RangeXTD WiFi Extender Not Working? Help!
Setting up a RangeXTD extender in the house helps a person to bid farewell to internet dead zones forever. But, the non-working state of the extender can affect the internet experience greatly. This blog will help you understand the common reasons behind the RangeXTD WiFi extender not working issue along with troubleshooting techniques to resolve them. Read on.
Reasons: RangeXTD WiFi Extender Not Working
The very common reason why a lot of people complaint about their extender not working is that they do not connect it to the router properly. Thus, we recommend you connect your WiFi extender to the main router. To ensure a stable connection, you are suggested to place both your devices in each others’ range. Apart from this, your devices must be compatible with each other.
Know that keeping both devices too close is just an invitation for another issue because WiFi signals will clash in that case. On the off-chance, you are sure that the connection between your devices is perfect, refer to the below-given points to understand what other reasons might have caused the problem.
Quick Tip: If your RangeXTD extender is operating in the Router mode, then we recommend you have a look at the Ethernet cable connecting your extender and the ADSL modem. It should be non-damaged. Also, it must be perfectly connected to the LAN ports of your devices.
- The power supply to the RangeXTD device is interrupted.
- You have not placed the range extender at the optimal location.
- The extender is stuck in a boot loop.
So, these were the most common reasons that might cause the RangeXTD WiFi extender not working issue. One more reason is the improper RangeXTD WiFi extender setup. Now, it is time to address the issue with the effective hacks mentioned in the next section.
How to Fix RangeXTD WiFi Extender Not Working Issue?
- Have a look at the socket that is supplying power to your RangeXTD device. Is it damaged? If it is, then you have found the reason bugging you with the non-working status of your range extender. We recommend you either getting it repaired or using another wall outlet for powering up the extender.
- The placement of the extender matters a lot when it comes to determining its working status. You are suggested to check the surroundings of your extender and see if there are any devices that emit electromagnetic wave. If there are, then you should change the RangeXTD location. Avoid keeping it near reflexive surfaces.
- Perform a simple reboot of your range extender. Perhaps, a boot loop has affected its ability in such a way that it is not working. To reboot the RangeXTD extender, it is recommended to unplug it from its respective wall outlet and wait for a few seconds. Once done, plug it back and see if things become normal.
In this way, you can make your RangeXTD extender work like normal once again. If things are still not in your favor, you are suggested to perform a factory reset of the extender by pressing its Reset button. After that, you can reconfigure it using the default IP.
The Final Thoughts
After following the above-given techniques, you will be able to address the RangeXTD WiFi extender not working issue. It is expected that you are now having a smooth experience with the extender. To avoid such an issue in the future, upgrade the range extender to the latest stable firmware version.